Mounting Bridge - Lunar System Installation Guide
Wall Bracket Anchoring
2x4 Wooden Studs
| Method | Stud Requirements | Fastener Requirements |
|---|---|---|
| Surface Mount | Min. 1 stud (center or off-center) | 1x fastener (min. 1/4” dia) into stud (min 2” depth) 1x fastener into wall with >=30lb anchor |
| Semi-Flush | 2 adjacent studs 14.5” apart(16” on center) | 4x #8 fasteners (2 per side) into studs (min 1” depth) |
Surface Mount
1
Dry fit bracket
Dry fit bracket over stud. Mark wall at bottom of Bridge, then measure up 22” to position bracket.
2
Install bracket
Install bracket using min. 2 screws (1 must be in stud).
3
Hang enclosure
Hang enclosure on bracket. The Bridge can slide +/- 1” for alignment.
4
Install anchors
Secure enclosure by installing two anchors through the lower embosses.
Semi-Flush Mount
Follow Wall Bracket Anchoring instructions.
Enclosure must extend at least 3” from wall surface for door clearance.
Door must be capable of opening >= 90°.